★ Dead zones & stuck valves

Sprinkler Valve & Solenoid Repair in DFW

Sprinkler valve repair from Lone Star Irrigation starts with testing the valve and its wiring. Stuck zones, leaking valves and dead zones are the usual causes, and a failed valve is normally replaced on the same visit.

We test the valve and the wiring before we replace anything
Done Right the First TimeTCEQ-licensed irrigators
Upfront PricingQuote before we start
Open 7 Days in SeasonMarch through November
The usual suspects

Signs of a bad sprinkler valve

Every zone in your system is opened and closed by one valve, or sometimes two, depending on how your system was designed. When a single zone stops while the rest run fine, the likely cause is a bad valve or wiring. It’s also one of the fastest sprinkler repairs on the whole system, when it’s diagnosed right the first time. We test the valve before replacing anything.

Zone won't turn on

Usually a bad valve or a broken wire, sometimes the controller or one of its modules. We test resistance at the controller and at the valve, and we test the controller as well.

Zone won't shut off

Debris under the diaphragm or a torn diaphragm. The valve is normally replaced: same visit, upfront price.

Valve box is a mystery

Buried, flooded, or unlabeled boxes located electronically, with no exploratory digging in the flower beds.

The coil

Sprinkler solenoid replacement

Every valve is fired by a solenoid, a small electromagnet that lives underground in Texas heat and does its job thousands of times a season. When one fails, its zone stops while the rest of the system runs fine. If the master valve fails, the whole system stops running. We test resistance at the controller and at the valve, and test the controller as well. When the valve has failed we normally replace it, because a repaired valve can’t be warrantied.

The valve

Zone won't turn on or won't shut off

A zone that won’t turn on usually means a bad valve or a broken wire. The controller can be the cause too, or one of the modules inside it, and an electrical surge that hits the controller can damage its electronics. We test resistance at the controller and at the valve, and test the controller as well. A zone that won’t shut off usually means debris under the diaphragm or a torn diaphragm, and the valve is normally replaced on the same visit with an upfront price. Wet ground and a high water bill with every zone working point to a leak instead: see sprinkler leak detection.

Questions

Sprinkler valve repair questions

How do I know if a sprinkler valve is bad?

A zone that won’t turn on, won’t shut off, or runs weak while others are fine usually points to the valve or its wiring. We test the valve before replacing anything.

Almost always debris holding the valve diaphragm open or a failed solenoid. Shut the system off at the controller; if it keeps running, use the shut-off valve and call.

We locate buried valves electronically with a wire tracer, with no digging up the flower beds hunting for them.

One dead zone is one bad valve away
from a green lawn.

4.7★ from 415 Google reviews · Done right the first time · Upfront quotes

Call NowBook Online